Effect of acidic solutions present in the diet on the surface roughness of microhybrid composite resins
DOI:
https://doi.org/10.33448/rsd-v11i4.26588Keywords:
Composite resins; Diet simulator solutions; Acidic solutions; Alcoholic solutions; Surface roughness.Abstract
The objective of this study was to evaluate in vitro the roughness and surface morphology of composite resins (CRs) stored for 180 days in acidic solutions present in the diet. Three micro-hybrid composite resins were used in this study (Charisma, Opallis, and Esthet-X). Fifty-one specimens were made of each material with 4 mm in diameter and 2 mm thick with the aid of an elastomer matrix. After photoactivation for 40 seconds (Elipar Free-Light / 3M ESPE), the specimens were stored in distilled water for 24 hours at 37ºC for subsequent surface polishing with Soft Lex / 3M ESPE discs in fine and extra-fine granulation. Then, the specimens were dried with absorbent paper and the surface roughness was measured using a rugosimeter. The specimens were then randomly divided into five groups (n=10) according to the tested solutions: DW - Distilled water (pH 5.30); RW - Red Wine / Trapiche Syha Ind. Argentina red wine (pH 3.68); CK – Coke / Coca Cola Co. (pH 2.73), OJ - Orange juice / Purity Cocamar (pH 3.58) and LBS - lactate buffer solution (pH 2.74). The tested solutions were changed daily. The surface roughness test was repeated after 15, 90 and 180 days of immersion. The average values of surface roughness were submitted to LSmeans analysis and Tukey-Kramer test, at a significance level of 5%. The results of surface roughness revealed that all CRs showed a significant increase in the roughness values over time for all tested solutions.
References
Camilotti, V., Mendonça, M. J., Dobrovolski, M., Detogni, A. C., Ambrosano, G. M. B., & De Goes, M. F. (2020). Impact of dietary acids on the surface roughness and morphology of composite resins. Journal of Oral Science, 63 (1), 18-21.
Cilli, R., Pereira, J. C., & Prakki, A. (2012). Properties of dental resins submitted to pH catalysed hydrolysis. Journal of Dentistry, 40, (12), 1144-1150.
Ciuris, C., Lynch, H. M., Wharton, C., & Johnston, C. S. (2019). A Comparison of Dietary Protein Digestibility, Based on DIAAS Scoring, in Vegetarian and Non-Vegetarian Athletes. Nutrients, 10, (12): 3016.
Francisconi, L. F., Honório, H. M., Rios, D., Magalhães, A. C., Machado, M. A., & Buzalaf, M. A. (2008). Effect of erosive pH cycling on different restorative materials and on enamel restored with these materials. Opertive Dentistry,33 (2), 203-208.
Habib, E. G., Wang, R., Wang, Y., Zhu, M., & Zhu, X. X. (2016). Inorganic Fillers for Dental Resin Composites - Present and Future. ACS Biomaterials Science & Engineering, 2 (1), 1-11.
Han, L., Okamoto, A., Fukushima, M., & Okiji, T. (2008). Evaluation of Flowable Resin Composite Surfaces Eroded by Acidic and Alcoholic Drinks. Dental Materials Journal, 27 (3), 455-465.
Hwang, S., Chung, S. H., Lee, J. T., Kim, Y. T., Kim, Y. J., Oh, S., & Yeo, I. L. (2018). Influence of Acid, Ethanol, and Anthocyanin Pigment on the Optical and Mechanical Properties of a Nanohybrid Dental Composite Resin. Materials, 11 (7), 1234.
Karaman, E., Tuncer, D., Firat, E., Ozdemir, O. S., & Karahan, S. (2014). Influence of Different Staining Beverages on Color Stability, Surface Roughness and Microhardness of Silorane and Methacrylate-based Composite Resins. Journal of Contemporary Dental Practice, 15 (3), 319-
Kocaağaoğlu, H., Aslan, T., Gürbulak, A., Albayrak, H., Taşdemir, Z., & Gumus, H. (2017). Efficacy of Polishing Kits on the Surface Roughness and Color Stabilit of Different Composite Resins. Nigerian Journal of Clinical Practice, 20 (5), 557-565.
Leite, M. L. A. S., Silva, F. D. S. C. M., Meireles, S. S., Duarte, R. M., & Andrade, A. K. M. (2014). The effect of drinks on color stability and surfasse roughness of nanocomposites. European Journal of Dentistry, 8 (3), 330-336.
Mohamed-Tahir, M. A., & Yap, A. U. (2004). Effects of pH on the surface texture of glass ionomer based/containing restorative materials. Operative Dentistry, 29 (5), 586-591.
Moszner, N., Fischer, U. K., Angermann, J., & Rheinberger, V. (2006). Bis-(acrylamide)s as new cross-linkers for resin-based composite restoratives. Dental Materials, 22 (12), 1157-1162.
Munack, J., Haubert, H,. Dogan, S., & Geurtsen, W. (2001). Effects of various storage media on surface hardness and structure of four polyacid-modified composite resins ("compomers"). Clinical Oral Investigations, 5 (4), 254-259.
Münchow, E. A., Ferreira, A. C., Machado, R. M., Ramos, T. S., Rodrigues-Junior, S. A., & Zanchi, C. H. (2014). Effect of acidic solutions on the surface degradation of a micro-hybrid composite resin. Brazilian Dental Journal, 25 (4), 321-326.
Owens, B. M., & Kitchens, M. (2007). The erosive potential of soft drinks on enamel surface substrate: an in vitro scanning electron microscopy investigation. Journal of Contemporary Dental Practice, 8 (7), 11-20.
Pfeifer, C. S. (2017). Polymer-Based Direct Filling Materials. Dental Clinics of North America, 61 (4), 733-750.
Prakki, A., Cilli, R., Mondelli, R. F., Kalachandra, S., & Pereira, J. C. (2005). Influence of pH environment on polymer based dental material properties. Journal of Dentistry, 33 (2), 91-98.
Sabbagh, J., Ryelandt, L., Bachérius, L., Biebuyck, J. J., Vreven, J., Lambrechts, P., & Leloup, G. (2004). Characterization of the inorganic fraction of resin composites. Journal of Oral Rehabilitation, 31 (11), 1090-1101.
Santerre, J. P., Shajii, L., & Leung, B. W. (2001). Relation of dental composite formulations to their degradation and the release of hydrolyzed polymeric-resin-derived products. Critical Reviews in Oral Biology & Medicine, 12 (2), 136-151.
Shabanian, M., & Richards, L. C. (2002). In vitro wear rates of materials under different loads and varying pH. Journal of Prosthetic Dentistry, 87 (6), 650-656.
Sideridou, I. D., & Achilias, D. S. (2005). Elution study of unreacted Bis-GMA, TEGDMA, UDMA, and Bis-EMA from light-cured dental resins and resin composites using HPLC. Journal of Biomedical Materials Research Part B: Applied Biomaterials, 74 (1), 617-626.
Soares, L. E., Cesar, I. C., Santos, C. G., De Cardoso, A. L., Liporoni, P. C., Munin, E., & Martin, A. A. (2007). Influence of coffee on reflectance and chemistry of resin composite protected by surface sealant. American Journal of Dentistry, 20 (5), 299-304.
Tanthanuch, S., Kukiattrakoon, B., Eiam-O-Pas, K., Pokawattana, K., Pamanee, N., Thongkamkaew, W., & Kochatung, A. (2018). Surface changes of various bulk-fill resin-based composites after exposure to different food-simulating liquid and beverages. Journal of Esthetic and Restorative Dentistry, 30 (2), 126-135.
Valinoti, A. C., Neves, B. G., Silva, E.M ., & Maia, L. C. (2008). Surface degradation of composite resins by acidic medicines and pH- cycling. Journal of Applied Oral Science, 16 (4), 257-265.
Vilela, A.L.R., Machado, A.C., Queiroz, L.L., Batista, P.H.M., Faria-E-Silva, A.L., Menezes, M.S. (2021). Effect of Interval Time between Corrosive and Abrasive Challenges on a Nanoparticulate Composite Resin. European Journal of Dentistry, 15 (4), 607-611.
Yazici, A.R., Tuncer, D., Antonson, S., Onen, A., Kilinc, E. (2010). Effects of delayed finishing/polishing on surface roughness, hardness and gloss of tooth-coloured restorative materials. European Journal of Dentistry, 4 (1), 50-56.
Yulianto, H.D.K., Rinastiti, M., Cune, M.S., de Haan-Visser, W., Atema-Smit, J., Busscher, H.J., van der Mei, H.C. (2019). Biofilm composition and composite degradationduring intra-oral wear. Dental Materials, 35 (5), 740-750.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Veridiana Camilotti; Anna Caroliny Detogni; Gláucia Maria Bovi Ambrosano; Márcio José Mendonça; Julio Katuhide Ueda; Mário Fernando De Goes
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
1) Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2) Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3) Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
